Prying and Opening Tool Assortment

  • Prying and Opening Tool Assortment
Prying and Opening Tool Assortment

9,99 $US

9,99 $US

Nous vous enverrons un message lorsque le produit sera à nouveau disponible.

Détails du produit

Description

Description

This tool assortment includes the most sought after Picks, Spudgers, Prying Tools, and more for electronics opening and component manipulation.

Includes:

Histoires de réparations

John Fitzgerald's Story Photo #1310284

Mon problème

The back button on my phone was operating as if it was being pressed randomly.

Ma solution

I've replaced the camera before (thanks to Ifixit), so the disassembly went smoothly.

Mon conseil

Because it isn't specifically in the guide, there are a couple of small pieces (I think a speaker cover and the vibrator (for lack of a . . .

Mon problème

The microphone had stopped working on my wife's first gen Pixel phone and warranty had lapsed about a month before.

Ma solution

Repair went pretty smoothly. Don't have a microwave so couldn't use the iOpener gel tube that came with repair kit (tried putting it in hot water but didn't really work) so used hair dr . . .

Mon problème

My battery was at times barely lasting for half the day. It would randomly shut down even while displaying a reasonable amount of power remaining. Processor slowdown is real and painful.

Ma solution

Removing the adhesive on the battery was the most difficult part. The tabs ripped as soon as I tugged on them, . . .

Mon problème

My phone still works great, but the battery was so old that it just wouldn't hold a decent charge anymore. The phone was not designed for the battery to be user-replaceable.

Ma solution

IFixIt assured me of how to go about it. I researched online and finally found a reputable replacement battery supplier, and I . . .

Mon problème

Extend the life and keep these material out of landfill or contamination of other natons..

Ma solution

Perfect.

Mon conseil

Not too hard, go for it!

Mon problème

My friend dropped my op1 and the red encoder hit the edge of the table. After the fall the red encoder only worked when holding pressure to the right and then spinning the encoder. Otherwise it would not register when turning it normally. I thought it just might be a mechanical issue but was not sur . . .

Voir plus