Introduction

The guide will teach you how to replace any faulty SCSI Connections at the back of the device. It requires the case to be opened, so any warranties covering the device will be voided.

Pièces

Aucune pièce nécessaire.

Pry 4 plastic feet off the bottom of the enclosure using the iPod opening tool. Pry 4 plastic feet off the bottom of the enclosure using the iPod opening tool. Pry 4 plastic feet off the bottom of the enclosure using the iPod opening tool.
  • Pry 4 plastic feet off the bottom of the enclosure using the iPod opening tool.

Ajouter un commentaire

Unscrew the four screws previously covered by the feet. Unscrew the four screws previously covered by the feet.
  • Unscrew the four screws previously covered by the feet.

Ajouter un commentaire

Flip the device right side up, then gently slide the casing upwards and off the hard drive. Flip the device right side up, then gently slide the casing upwards and off the hard drive.
  • Flip the device right side up, then gently slide the casing upwards and off the hard drive.

Ajouter un commentaire

Flip device upside down again.
  • Flip device upside down again.

  • Gently pry the bottom gray casing away from the device.

Ajouter un commentaire

Rotate so back of device is facing you, then gently pry the back casing away. When back casing is removed, the fan will become loose.
  • Rotate so back of device is facing you, then gently pry the back casing away.

  • When back casing is removed, the fan will become loose.

Ajouter un commentaire

Flip so device is upside down. Remove 4 screws with Phillips #1 screw driver.
  • Flip so device is upside down.

  • Remove 4 screws with Phillips #1 screw driver.

    • Be sure to save the washers that seperate the screws from the baseplate for reassembly.

Ajouter un commentaire

Slide the internal drive component away from the back of the device. Remove the connections from the back of the internal component in the order of your choosing, we suggest left to right. The connections are:
  • Slide the internal drive component away from the back of the device.

  • Remove the connections from the back of the internal component in the order of your choosing, we suggest left to right. The connections are:

    • Audio Connection

    • SCSI ID

    • Terminate On

    • SCSI Connection

    • DC Input (power)

Ajouter un commentaire

Remove the four Phillips #1 Screws from back panel. Once the screws are removed, the two connections are easily removed from the body. Once the screws are removed, the two connections are easily removed from the body.
  • Remove the four Phillips #1 Screws from back panel.

  • Once the screws are removed, the two connections are easily removed from the body.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Patrick Meyer

Membre depuis le 10/04/2011

83 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 24-60, Amido Spring 2011 Membre de l'équipe Cal Poly, Team 24-60, Amido Spring 2011

CPSU-AMIDO-S11S24G60

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 673