Introduction

Here, the back cover will be removed followed by the secondary back panel. Once this is completed and the motherboard is visible, the vibration motor is accessible and can be replaced.

Using the blue plastic opening tool, insert the tip into the crease between the back cover and the phone and pry it upwards. Work your way around the phone until the entire back cover is loose.
  • Using the blue plastic opening tool, insert the tip into the crease between the back cover and the phone and pry it upwards.

  • Work your way around the phone until the entire back cover is loose.

Ajouter un commentaire

Remove the thirteen 3.6 mm screws using the torx T5 bit in the screwdriver. Remove the thirteen 3.6 mm screws using the torx T5 bit in the screwdriver.
  • Remove the thirteen 3.6 mm screws using the torx T5 bit in the screwdriver.

Ajouter un commentaire

Using the blue plastic opening tool, insert the tip into the crease between the mid-frame and the phone and pry it upwards. Work your way around the phone until the entire back cover is loose and remove the mid-frame.
  • Using the blue plastic opening tool, insert the tip into the crease between the mid-frame and the phone and pry it upwards.

  • Work your way around the phone until the entire back cover is loose and remove the mid-frame.

Ajouter un commentaire

Using a spudger, pry the vibration motor connector from the motherboard.
  • Using a spudger, pry the vibration motor connector from the motherboard.

Ajouter un commentaire

Gently pry the vibration motor upwards using the spudger.
  • Gently pry the vibration motor upwards using the spudger.

  • The vibration motor is held down by some adhesive, force might be needed to remove it.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ryan

Membre depuis le 14/05/2012

223 Réputation

2 tutoriels rédigés

Équipe

USF Tampa, Team 8-4, Leahy Fall 2014 Membre de l'équipe USF Tampa, Team 8-4, Leahy Fall 2014

USFT-LEAHY-F14S8G4

4 membres

5 tutoriels rédigés

That is not the speaker, that is the motor for the vibrate functions...

The speaker is located in the plastic back of the housing near the camera hole.

tee1331 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 4

30 derniers jours : 5

Total : 1,196