Introduction

The stand supports the monitor from falling over.

Lay the monitor on a flat surface so that the back is facing up.
  • Lay the monitor on a flat surface so that the back is facing up.

Ajouter un commentaire

Grab the hinge cover with both hands on either side of the stand. Squeeze inwards with your thumbs and fingers and lift up to remove the hinge cover.
  • Grab the hinge cover with both hands on either side of the stand.

  • Squeeze inwards with your thumbs and fingers and lift up to remove the hinge cover.

Ajouter un commentaire

Remove the four 12.1 mm Phillips #2 screws that hold the stand to the monitor. Support the monitor while removing the screws to prevent the monitor from falling.
  • Remove the four 12.1 mm Phillips #2 screws that hold the stand to the monitor.

  • Support the monitor while removing the screws to prevent the monitor from falling.

  • Lift up to detach the stand.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Keith

Membre depuis le 06/10/2011

246 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 20-26, Maness Fall 2011 Membre de l'équipe Cal Poly, Team 20-26, Maness Fall 2011

CPSU-MANESS-F11S20G26

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 6

7 derniers jours : 47

30 derniers jours : 181

Total : 2,320