Introduction

This guide will show you how to replace the memory in your Acer Aspire 6530-6522. You will need to do this f you are upgrading to more memory, or if your memory has become damaged or faulty and you have a new one.

Pièces

Aucune pièce nécessaire.

Make sure the device is unplugged and completely powered down. Turn the device over.
  • Make sure the device is unplugged and completely powered down.

  • Turn the device over.

Ajouter un commentaire

The lock switch can slide either towards or away from the battery.  If it is pushed towards the battery, the release switch is locked and the battery can not be released. Slide the switch away from the battery.
  • The lock switch can slide either towards or away from the battery. If it is pushed towards the battery, the release switch is locked and the battery can not be released.

  • Slide the switch away from the battery.

Ajouter un commentaire

The battery release switch is just to the inside of the battery and slides parallel to it. Push the switch to the side. It is not just an open or close switch, it actually pops the battery up so you will feel some resistance. When inserting a battery back into the device, you do not need to touch this switch. Just press the battery firmly down, you will see and hear this switch catch.
  • The battery release switch is just to the inside of the battery and slides parallel to it.

  • Push the switch to the side. It is not just an open or close switch, it actually pops the battery up so you will feel some resistance.

  • When inserting a battery back into the device, you do not need to touch this switch. Just press the battery firmly down, you will see and hear this switch catch.

Ajouter un commentaire

Pull the battery up and out. Use a plastic opening tool if necessary. Pull the battery up and out. Use a plastic opening tool if necessary. Pull the battery up and out. Use a plastic opening tool if necessary.
  • Pull the battery up and out. Use a plastic opening tool if necessary.

Ajouter un commentaire

Using a Phillips #1 screwdriver, remove the nine 7mm screws holding the back panel. Using a Phillips #1 screwdriver, remove the nine 7mm screws holding the back panel.
  • Using a Phillips #1 screwdriver, remove the nine 7mm screws holding the back panel.

Ajouter un commentaire

Pull the release latches outward. The memory module should lift up.
  • Pull the release latches outward. The memory module should lift up.

  • Pull the memory up and out at about a 45 degree angle.

  • Repeat for the second module (if necessary).

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Patrick McKenna

Membre depuis le 20/03/2018

593 Réputation

5 tutoriels rédigés

Équipe

UMass Dartmouth, Team S5-G6, Peak Spring 2018 Membre de l'équipe UMass Dartmouth, Team S5-G6, Peak Spring 2018

UMASSD-PEAK-S18S5G6

3 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 14