Introduction

The fan often needs replacement if the device is overheating or making loud noises while running. Some common tools will be needed for this replacement, such as a T6 Torx screwdriver and a Phillips #01 screwdriver. To determine if the fan needs to be replaced, please refer to this device's troubleshooting page.

Pièces

Aucune pièce nécessaire.

Remove the back panel by unscrewing all marked 3mm screws with a T6 Torx screwdriver. Remove these screws with a T6 Torx screwdriver, but note that these feet screws are 4mm in length.
  • Remove the back panel by unscrewing all marked 3mm screws with a T6 Torx screwdriver.

  • Remove these screws with a T6 Torx screwdriver, but note that these feet screws are 4mm in length.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Unscrew the marked 2mm screws with a Phillips #01 screwdriver. Remove the fan by disconnecting the marked tabs.
  • Unscrew the marked 2mm screws with a Phillips #01 screwdriver.

  • Remove the fan by disconnecting the marked tabs.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nicholas Wise

Membre depuis le 14/02/2018

595 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S2-G6, Eyestone Spring 2018 Membre de l'équipe USF Tampa, Team S2-G6, Eyestone Spring 2018

USFT-EYESTONE-S18S2G6

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 14