Introduction

Replace the speaker in your Acer Iconia Tab 500.

Pièces

Aucune pièce nécessaire.

To start, gently separate one corner of the case using the black spudger.
  • To start, gently separate one corner of the case using the black spudger.

Ajouter un commentaire

Once you have successfully pried the spudger in between the front case and back case, continue do so around the entire tablet until the back case is completely disconnected.
  • Once you have successfully pried the spudger in between the front case and back case, continue do so around the entire tablet until the back case is completely disconnected.

Ajouter un commentaire

Locate the 4 screws and cable that hold in the two speakers.
  • Locate the 4 screws and cable that hold in the two speakers.

    • Use the Phillips #1 screwdriver to remove these 2mm black screws.

    • Remove the 2mm silver screws.

      • Not all 4 screws are going to be the same kind. This will not affect the speaker replacement.

    • Connector Cable

Ajouter un commentaire

Carefully remove the connector cable by pushing on the rim of black plastic insert.
  • Carefully remove the connector cable by pushing on the rim of black plastic insert.

Ajouter un commentaire

Unfortunately, the top speaker is a wedged under the motherboard.
  • Unfortunately, the top speaker is a wedged under the motherboard.

  • To get this speaker out, use the spudger and gently pry it out.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Kyle Libby

Membre depuis le 07/04/2014

928 Réputation

11 tutoriels rédigés

Équipe

Cal Poly, Team 7-23, Regan Spring 2014 Membre de l'équipe Cal Poly, Team 7-23, Regan Spring 2014

CPSU-REGAN-S14S7G23

4 membres

14 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 13

Total : 1,520