Introduction

The alarm unit is located behind the glove box. Once the glovebox is out of the way, you can remove the black plastic alarm unit, open it and change the dip switch for a less sensitive setting.

Pièces

Aucune pièce nécessaire.

Ajouter un commentaire

Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.
  • Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.

Ajouter un commentaire

It may be stubborn to get out because it is stuck down with double stick foam pads.
  • It may be stubborn to get out because it is stuck down with double stick foam pads.

Ajouter un commentaire

Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.
  • Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.

Ajouter un commentaire

Turn the board over and locate the 2 position dip switch.
  • Turn the board over and locate the 2 position dip switch.

  • This dip switch adjusts the glass breakage microphone sensitivity

  • Sensitivity settings:

  • 1 off & 2 off = high

  • 1 on & 2 off = mid (factory setting)

  • 1 off & 2 on = low

  • 1 on & 2 on = super low

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

mpeeples

Membre depuis le 04/04/2010

184 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 10

Total : 1,792