Introduction

There are several steps to be done before you will have access to the sound card. These steps include removing the keyboard, RAM, hard drive, and display.

Pièces

Aucune pièce nécessaire.

Pull the keyboard tabs toward you while lifting up on the keyboard until it releases from it's hold.
  • Pull the keyboard tabs toward you while lifting up on the keyboard until it releases from it's hold.

  • To lift the keyboard out pull it up and away from you. Then place the keyboard on the track pad.

Ajouter un commentaire

Pull the keyboard ribbon vertically from the logic board to release connection.
  • Pull the keyboard ribbon vertically from the logic board to release connection.

  • The connector may be tight and difficult to remove. If stuck try rocking the connector back and forth while pulling up until it releases. This same process can be used for many of the connectors on this device.

  • Remove battery and CD/DVD drives before proceeding any further.

Ajouter un commentaire

Your computer should look approximately like this.
  • Your computer should look approximately like this.

Ajouter un commentaire

Remove the two silver Phillips #1 screws that attach the heat shield to the metal framework.
  • Remove the two silver Phillips #1 screws that attach the heat shield to the metal framework.

  • Lift the heat shield up and toward you.

Ajouter un commentaire

Pull the PRAM battery cable vertically upward to disconnect it.
  • Pull the PRAM battery cable vertically upward to disconnect it.

  • Remove the battery by pulling up and to the left.

Ajouter un commentaire

Remove the two T8 Torx screws that attach the heat sink to the processor.
  • Remove the two T8 Torx screws that attach the heat sink to the processor.

  • Remove the long silver Phillips #1 screw from the heat sink.

Ajouter un commentaire

Lift up the heat sink unit from the left side and remove.
  • Lift up the heat sink unit from the left side and remove.

Ajouter un commentaire

Lift the processor on the right side and pull directly up.
  • Lift the processor on the right side and pull directly up.

  • The RAM chips should be in the slots on the processor.

Ajouter un commentaire

After removing the RAM, your laptop should now look like this.
  • After removing the RAM, your laptop should now look like this.

Ajouter un commentaire

Locate the orange tab, which should be just left of the hard-drive.
  • Locate the orange tab, which should be just left of the hard-drive.

  • You must disconnect this orange tab from the logic board to enable the next step.

  • It is better to do this by grabbing the plastic connection point, not the relatively flexible cable.

Ajouter un commentaire

Grab the plastic strip shown here and gently remove, pulling up and left.
  • Grab the plastic strip shown here and gently remove, pulling up and left.

  • Pull left to avoid the hard drive catching the casing.

Ajouter un commentaire

Once you have removed the hard-drive, your laptop should like this.
  • Once you have removed the hard-drive, your laptop should like this.

Ajouter un commentaire

Remove the single black Torx screw from the modem.
  • Remove the single black Torx screw from the modem.

  • Remove the black rectangle that is being held on by the one Torx screw.

Ajouter un commentaire

Using your fingers, lift the modem from the socket it is plugged into.
  • Using your fingers, lift the modem from the socket it is plugged into.

Ajouter un commentaire

Disconnect the cable that is attached to the end of the modem to remove the modem.
  • Disconnect the cable that is attached to the end of the modem to remove the modem.

Ajouter un commentaire

Your computer will look approximately like this.
  • Your computer will look approximately like this.

Ajouter un commentaire

Push the display back.
  • Push the display back.

  • Put your index finger under the power button and gently pull the clutch cover back.

  • Repeat for the left side.

Ajouter un commentaire

Lift the clutch cover up and off.  Pull it towards yourself.
  • Lift the clutch cover up and off. Pull it towards yourself.

Ajouter un commentaire

Disconnect the display cable from the logic board.
  • Disconnect the display cable from the logic board.

Ajouter un commentaire

Remove the Torx screw that holds the display cable.
  • Remove the Torx screw that holds the display cable.

  • Pull out thick display inverter board by pulling it up and out. Two tabs will be holding it in place, you need to get pass these to pull the board free.

Ajouter un commentaire

Disconnect the white inverter cable.  Pull it towards the left.
  • Disconnect the white inverter cable. Pull it towards the left.

Ajouter un commentaire

Disconnect the inverter plug by pulling it up from the logib board.
  • Disconnect the inverter plug by pulling it up from the logib board.

Ajouter un commentaire

Turn the laptop around.
  • Turn the laptop around.

  • Open the port door.

  • Remove the four Torx screws.

Ajouter un commentaire

Turn the laptop so the front faces you.
  • Turn the laptop so the front faces you.

  • Pull the black Airport antenna up.

Ajouter un commentaire

Pull the display up as you hold it firmly with both hands.
  • Pull the display up as you hold it firmly with both hands.

Ajouter un commentaire

Your laptop should look something like this.
  • Your laptop should look something like this.

Ajouter un commentaire

Disconnect the large orange wire that is shown.
  • Disconnect the large orange wire that is shown.

Ajouter un commentaire

Take out the one short black and three long silver Torx screws from casing.
  • Take out the one short black and three long silver Torx screws from casing.

Ajouter un commentaire

Slide the black plastic shield away from you and out from under the hard plastic casing.
  • Slide the black plastic shield away from you and out from under the hard plastic casing.

  • Disconnect the orange cable from the logic board.

  • Take out the two long silver Torx screws.

Ajouter un commentaire

Turn your laptop over.
  • Turn your laptop over.

  • Take out the five small Torx screws from casing.

  • Remove the two long Torx screws and make sure these are put back in the right place when reassembling your device.

Ajouter un commentaire

Turn your laptop back over.
  • Turn your laptop back over.

  • Remove the three small black Torx screws from the frame.

  • Remove the small Torx screw that holds the logic board to the casing on the left.

Ajouter un commentaire

Hold the upper casing in the place shown and pull it back to release the lock. When the lock has released, pull up just enough to keep the case from locking again.
  • Hold the upper casing in the place shown and pull it back to release the lock. When the lock has released, pull up just enough to keep the case from locking again.

Ajouter un commentaire

The eject button on the left side of the laptop keeps the upper casing from lifting up. To get around this, you must push the button in to the point that the upper casing can pass by the button and continue lifting up.
  • The eject button on the left side of the laptop keeps the upper casing from lifting up. To get around this, you must push the button in to the point that the upper casing can pass by the button and continue lifting up.

Ajouter un commentaire

Lift up the left side of the upper case just enough so that the two audio cables connected to the sound card can be disconnected.
  • Lift up the left side of the upper case just enough so that the two audio cables connected to the sound card can be disconnected.

  • Do not lift the upper casing too far without disconnecting the audio cables otherwise there is a possibility of damaging the sound card.

  • After disconnecting the audio cables remove the upper casing.

Ajouter un commentaire

Your laptop should look something like this.
  • Your laptop should look something like this.

Ajouter un commentaire

Take out the two long silver Torx screws from the power card.
  • Take out the two long silver Torx screws from the power card.

  • Hold the power card near the black plastic shielding and lift up to remove power card.

Ajouter un commentaire

Lightly hold the metal shield on the left side of it and slowly pull up and toward the front of the laptop.
  • Lightly hold the metal shield on the left side of it and slowly pull up and toward the front of the laptop.

  • These clips will bend very easily and need to be handled with care when taking it out of the laptop.

Ajouter un commentaire

Remove the black Torx screw from the metal frame that it is holding it to the bottom casing.
  • Remove the black Torx screw from the metal frame that it is holding it to the bottom casing.

  • Using a 5mm wrench or needle-nose pliers remove the small nut from the bolt.

Ajouter un commentaire

Disconnect the fan power cable on the left side of the laptop.
  • Disconnect the fan power cable on the left side of the laptop.

Ajouter un commentaire

Rotate the laptop 180 degrees so that the back is facing you.
  • Rotate the laptop 180 degrees so that the back is facing you.

  • Lift up the left side of the metal frame and remove the one black Torx screw.

Ajouter un commentaire

Hold the filter by the black end and rotate the filter toward the front of the laptop. Then pull it up and above the frame.
  • Hold the filter by the black end and rotate the filter toward the front of the laptop. Then pull it up and above the frame.

  • Take out the metal frame.

Ajouter un commentaire

Your laptop should look something like this.
  • Your laptop should look something like this.

Ajouter un commentaire

Lift up on the sound card from both the left and the right sides and remove.
  • Lift up on the sound card from both the left and the right sides and remove.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kevin Keegan

Membre depuis le 19/04/2011

67 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 4-2, Regan Spring 2011 Membre de l'équipe Cal Poly, Team 4-2, Regan Spring 2011

CPSU-REGAN-S11S4G2

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 1,454