Introduction

This guide covers how to take out all the filters on the vacuum to either clean or replace them. All steps are accompanied by photos to help you through the process.

Grab hold of both the flex hose handle  and the extension wand. Pull straight out to detach the handle from the extension wand.
  • Grab hold of both the flex hose handle and the extension wand.

  • Pull straight out to detach the handle from the extension wand.

Ajouter un commentaire

Locate the lock clip on the other end of the flex hose.
  • Locate the lock clip on the other end of the flex hose.

- color code this step to match the red indicator

-watch out for the lighting (hard shadows)

Austin Marshall - Réponse

Hold down the lock clip to unlock the flex hose from the vacuum. Remove the flex hose from the vacuum.
  • Hold down the lock clip to unlock the flex hose from the vacuum.

  • Remove the flex hose from the vacuum.

Ajouter un commentaire

After removing hose, place vacuum on back and unclip the top compartment. Open the compartment. Pull the dirt collection box out of the vacuum.
  • After removing hose, place vacuum on back and unclip the top compartment.

  • Open the compartment.

  • Pull the dirt collection box out of the vacuum.

Ajouter un commentaire

Place dirt collection box to the side. Locate the Pre-Motor Filter. Pull the filter out by grabbing the pull tab on top.
  • Place dirt collection box to the side.

  • Locate the Pre-Motor Filter.

  • Pull the filter out by grabbing the pull tab on top.

Ajouter un commentaire

Turn vacuum around and locate the filter cover on the bottom. Place fingers in the opening and pull off the filter cover. Place fingers on each tab on the Post-Motor HEPA Media Filter and pull out.
  • Turn vacuum around and locate the filter cover on the bottom.

  • Place fingers in the opening and pull off the filter cover.

  • Place fingers on each tab on the Post-Motor HEPA Media Filter and pull out.

Ajouter un commentaire

Take filter out to clean or replace. To clean Dirt Collection Box, unlatch lid and take off. To clean Dirt Collection Box, unlatch lid and take off.
  • Take filter out to clean or replace.

  • To clean Dirt Collection Box, unlatch lid and take off.

Ajouter un commentaire

Flip Dirt Collection Box over and locate the push tab. Push the Dirt Cup HEPA Media Filter up to take it off. Picture 3 Shows all the filters taken out of the vacuum.
  • Flip Dirt Collection Box over and locate the push tab.

  • Push the Dirt Cup HEPA Media Filter up to take it off.

  • Picture 3 Shows all the filters taken out of the vacuum.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Austin Marshall

Membre depuis le 18/01/2018

121 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team S12-G1, Banghart Winter 2018 Membre de l'équipe Cal Poly, Team S12-G1, Banghart Winter 2018

CPSU-BANGHART-W18S12G1

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 51