Introduction

The pivot button may need to be installed if problems such as jamming of the button occur. This guide will outline how to install the pivot button on the Black and Decker Pivot Plus PD600.

Pièces

Aucune pièce nécessaire.

Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver. Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver.
  • Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver.

Ajouter un commentaire

After the screw is removed, take off both sides of the button. You will be left with 3 pieces. Two halves of the button (a black piece with a lock on the front, and a circular orange piece) will be left over along with a spring.
  • After the screw is removed, take off both sides of the button.

  • You will be left with 3 pieces. Two halves of the button (a black piece with a lock on the front, and a circular orange piece) will be left over along with a spring.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ryan Angelich

Membre depuis le 13/05/2013

101 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 4-15, Maness Spring 2013 Membre de l'équipe Cal Poly, Team 4-15, Maness Spring 2013

CPSU-MANESS-S13S4G15

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 711