Introduction

Use this repair guide to install the screen in the Blackberry Pearl 8100

Pièces

Aucune pièce nécessaire.

Before working on the phone, be sure that the phone is turned off. Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.
  • Before working on the phone, be sure that the phone is turned off.

  • Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.

Ajouter un commentaire

  • Remove the battery located directly below back panel.

Ajouter un commentaire

Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.
  • Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.

Ajouter un commentaire

Using the spudger, pry off the small portion of the casing located at the bottom of the phone. Using the spudger, pry off the small portion of the casing located at the bottom of the phone.
  • Using the spudger, pry off the small portion of the casing located at the bottom of the phone.

Ajouter un commentaire

Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.
  • Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.

Ajouter un commentaire

Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.
  • Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.

Ajouter un commentaire

Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face.  Remove the back body panel. Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face.  Remove the back body panel.
  • Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face. Remove the back body panel.

Ajouter un commentaire

Separate the logic board from the front panel.
  • Separate the logic board from the front panel.

Ajouter un commentaire

Gently remove the keyboard from front casing. It should snap out of place. Gently remove the keyboard from front casing. It should snap out of place.
  • Gently remove the keyboard from front casing. It should snap out of place.

Ajouter un commentaire

After removing the logic board, place spudger between the logic board and screen and remove the screen, sliding it slowly away.
  • After removing the logic board, place spudger between the logic board and screen and remove the screen, sliding it slowly away.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Robert Cronin

Membre depuis le 08/04/2010

520 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 34-57, Forte Spring 2010 Membre de l'équipe Cal Poly, Team 34-57, Forte Spring 2010

CPSU-FORTE-S10S34G57

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 2,706