Introduction

The grips for the 60D come off easy, they just peel off. For many 60D owners, Canon already helped you by choosing a poor / defective adhesive for the first few batches of cameras shipped.

Pièces

Aucune pièce nécessaire.

Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.
  • Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.

  • Repeat for the other two grips

  • The large one on the battery-side is the easiest to start with. This is required to remove the front & back panels

  • The small one on the back is a bit difficult to get started, but not really difficult to remove.

  • The one on the AV panel will be easier if you open up the AV port cover.

  • Remove the adhesive like you would rubber cement, just rub your finger against it, it will come off.

  • Optionally throw the balled up adhesive at people pretending its a booger :)

Ajouter un commentaire

Conclusion

Double stick tape, or rubber cement (placed carefully) should work well. Studio-mount (sheets of double-stick tape) cut to size should also work.

10 autre(s) ont terminé cette réparation.

Eric D

Membre depuis le 13/11/2012

1 026 Réputation

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 15

30 derniers jours : 73

Total : 9,766