Introduction

This guide will instruct you how to install the flash on your camera.

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Ajouter un commentaire

Using your finger, peel back the textured grip so the components are separated. Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

Ajouter un commentaire

Using the flat end of a spudger, loosen the connection between the front panel and the device. Remove the front panel using your hands. Remove the front panel using your hands.
  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

Ajouter un commentaire

Pop the flash up with your thumb Pop the flash up with your thumb
  • Pop the flash up with your thumb

Ajouter un commentaire

Unscrew the two screws on the front of the flash near the bulb cover.
  • Unscrew the two screws on the front of the flash near the bulb cover.

Ajouter un commentaire

Close the flash. Lift the flash cover off. Lift the flash cover off.
  • Close the flash.

  • Lift the flash cover off.

Ajouter un commentaire

Pull off yellow capacitor from flash wiring. Pull off yellow capacitor from flash wiring.
  • Pull off yellow capacitor from flash wiring.

Ajouter un commentaire

Remove white cocking with a razor blade, and then unsolder connection.
  • Remove white cocking with a razor blade, and then unsolder connection.

Ajouter un commentaire

Remove the flash cover to access the flash bulb. After wires are unsoldered, slide flash bulb out from housing.
  • Remove the flash cover to access the flash bulb.

  • After wires are unsoldered, slide flash bulb out from housing.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Zach

Membre depuis le 04/04/2012

40 Réputation

8 tutoriels rédigés

Équipe

Cal Poly, Team 14-9, Forte Spring 2012 Membre de l'équipe Cal Poly, Team 14-9, Forte Spring 2012

CPSU-FORTE-S12S14G9

5 membres

12 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 16

Total : 1,608