Réparez vos affaires Communauté Boutique

Canon PowerShot SD700 LCD screen Replacement

Introduction

Follow these steps to remove and install a new LCD screen.

Ce dont vous avez besoin

  1. Canon PowerShot SD700 LCD screen Replacement, Outside Case: étape 1, image 1 de 1

    • Turn off the camera by pressing the power button above the LCD screen.

    Traduire

  2. Canon PowerShot SD700 LCD screen Replacement: étape 2, image 1 de 1

    • Remove the two, small screws on the bottom of the camera using a Phillip's #00 screwdriver.

    Traduire

  3. Canon PowerShot SD700 LCD screen Replacement: étape 3, image 1 de 1

    • Use a Phillips #00 screwdriver to remove the two, small screws on the right side of the camera.

    Traduire

  5. Canon PowerShot SD700 LCD screen Replacement: étape 4, image 1 de 1

    • Use a Phillips #00 screwdriver to remove the screw on the left of the camera under the A/V out Digital label.

    Traduire

  6. Canon PowerShot SD700 LCD screen Replacement: étape 5, image 1 de 1

    • Use a Phillips #00 screwdriver, remove the screw on the bottom of the camera near the battery and memory card slots.

    • This screw will be longer than the rest of the screws.

    Traduire

  7. Canon PowerShot SD700 LCD screen Replacement: étape 6, image 1 de 1

    • Remove the front, back, and side casings from the camera and set to the side.

    Traduire

  8. Canon PowerShot SD700 LCD screen Replacement, LCD screen: étape 7, image 1 de 1

    • Remove the two screws that connect the LCD and backlight to the main body of the camera.

    Traduire

  9. Canon PowerShot SD700 LCD screen Replacement: étape 8, image 1 de 3 Canon PowerShot SD700 LCD screen Replacement: étape 8, image 2 de 3 Canon PowerShot SD700 LCD screen Replacement: étape 8, image 3 de 3

    • Gently pry the LCD and the backlight from the main body of the camera.

    • Gently pry the LCD from the backlight.

    • The thin ribbon cable is for the backlight.

    • The thick ribbon cable is for the LCD screen.

    Traduire

  10. Canon PowerShot SD700 LCD screen Replacement: étape 9, image 1 de 1

    • Carefully lift the ZIF connector that covers the thick ribbon cable.

    • This ZIF connector is fragile. Use caution when lifting it from its down position.

    • Insert the new LCD and reassemble the camera.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Auteur

avec 5 autres contributeurs

Emilio Rossi

Membre depuis le 04/07/11

113 Réputation

3 tutoriels rédigés

Badges: 8

+ 5 badges supplémentaires

Équipe

Cal Poly, Team 9-71, Walters Spring 2011 Membre de l'équipe Cal Poly, Team 9-71, Walters Spring 2011

CPSU-WALTERS-S11S9G71

4 membres

9 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 6

Total : 2,592