Introduction

How to remove the outer casing of your Canon PowerShot SD870 IS.

Pièces

Aucune pièce nécessaire.

Remove the wrist strap, if present.
  • Remove the wrist strap, if present.

  • Remove the lithium-ion battery.

Ajouter un commentaire

Remove the two 4 mm Phillips #00 screws on the bottom of the camera. Remove the screw next to the wrist strap attachment. Pull up the “A/V OUT DIGITAL” cover and remove the screw above the USB port.
  • Remove the two 4 mm Phillips #00 screws on the bottom of the camera.

  • Remove the screw next to the wrist strap attachment.

  • Pull up the “A/V OUT DIGITAL” cover and remove the screw above the USB port.

Note: The PH000 bit from my iFixit toolkit fits the screws better than the PH00 described above. The 00 bit is too pointed to bottom out in the screw and therefore does not engage as well.

wayne - Réponse

Carefully unhook the “A/V OUT DIGITAL” cover from the hinge.
  • Carefully unhook the “A/V OUT DIGITAL” cover from the hinge.

With the camera I was repairing, to remove the front cover as shown below, it was necessary to first remove the two smaller screws on the opposite end of the body from the “A/V OUT DIGITAL” cover. That is . . . the screws shown in step 5 which in my camera also hold the front cover in place (design change apparently).

RWM

wayne - Réponse

Pull the front cover from the camera by  using gentle upward pressure. Pull the front cover from the camera by  using gentle upward pressure.
  • Pull the front cover from the camera by using gentle upward pressure.

Ajouter un commentaire

Remove the two Phillips #00 screws from the flat end of the camera. Remove the black L-shaped side cover plate.
  • Remove the two Phillips #00 screws from the flat end of the camera.

  • Remove the black L-shaped side cover plate.

  • Remove the silver u-shaped retainer plate.

Ajouter un commentaire

Slide the back casing off.
  • Slide the back casing off.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Zach pelley

Membre depuis le 19/04/2010

58 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 10-45, Garner Spring 2010 Membre de l'équipe Cal Poly, Team 10-45, Garner Spring 2010

CPSU-GARNER-S10S10G45

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 7,796