Introduction

The switch is an essential piece of the Craftsman Model 315.10721. Even if the motor and inner hardware is working, if the switch is broken, the saw will not start.

Pièces

Aucune pièce nécessaire.

Remove the two 1" Phillips screws using a #1 Phillips screwdriver.
  • Remove the two 1" Phillips screws using a #1 Phillips screwdriver.

  • Remove the three 1/2" Phillips screws using a #1 Phillips screwdriver.

  • Once the five screws are removed, lift the handle cover from the saw.

Ajouter un commentaire

Using a Phillips #1 screwdriver, remove the 1/2" silver screw that is securing the switch.
  • Using a Phillips #1 screwdriver, remove the 1/2" silver screw that is securing the switch.

Ajouter un commentaire

Using a Phillips #00 screwdriver or a small diameter screwdriver, gently insert it into the leads. When the screwdriver is inserted into the lead, it will release the wire.
  • Using a Phillips #00 screwdriver or a small diameter screwdriver, gently insert it into the leads. When the screwdriver is inserted into the lead, it will release the wire.

    • The leads are where the black and white wires from the switch are plugged in.

  • Release both sets of the black and white wires and gently pull them from the leads.

  • To install the new switch, insert the wires of the new cord in the same way that they were removed.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Riley Hilliker

Membre depuis le 14/10/2014

546 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 4-47, Amido Fall 2014 Membre de l'équipe Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 8

Total : 388