Flip your bike so the seat and handlebars are on the ground.
  • Flip your bike so the seat and handlebars are on the ground.

Ajouter un commentaire

Slip the chain onto the crank and rear cog. Then insert wheel into rear drop-outs.
  • Slip the chain onto the crank and rear cog. Then insert wheel into rear drop-outs.

  • Make sure that the chain is on the correct side of the wheel

Ajouter un commentaire

Tighten brake strap using screwdriver and 10mm socket wrench. Hold the nut on the inside (near the spokes) with wrench as you tighten the screw with the screwdriver.
  • Tighten brake strap using screwdriver and 10mm socket wrench. Hold the nut on the inside (near the spokes) with wrench as you tighten the screw with the screwdriver.

Ajouter un commentaire

Center the wheel and pull back to tighten the chain
  • Center the wheel and pull back to tighten the chain

Ajouter un commentaire

With wheel pulled back, tighten the two axle nuts using the 15mm socket wrench. Tighten the non-drive side (side without the chain) first.
  • With wheel pulled back, tighten the two axle nuts using the 15mm socket wrench. Tighten the non-drive side (side without the chain) first.

  • Wheel will angle as you tighten. Keep it centered with your hand as you finish tightening both axle nuts.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Erin Heimburge

Membre depuis le 11/07/2013

27 Réputation

1 tutoriel rédigé

Équipe

UC Santa Barbara, Team 2-1, Bradley Spring 2013 Membre de l'équipe UC Santa Barbara, Team 2-1, Bradley Spring 2013

UCSB-BRADLEY-S13S2G1

4 membres

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 8

7 derniers jours : 43

30 derniers jours : 229

Total : 4,880