Introduction

The fan removes warm air from the inside of the projector. If the fan is not working correctly, the projector could overheat and damage could occur.

This guide can also help to keep the fan clean from dust and dirt to prevent overheating.

Pièces

Aucune pièce nécessaire.

Make sure the projector is unplugged before starting Place the projector upside down to access the screws on the bottom.
  • Make sure the projector is unplugged before starting

  • Place the projector upside down to access the screws on the bottom.

  • Remove the five 7mm long screws using a #3 Phillips screwdriver at least 2 inches long.

Ajouter un commentaire

Flip the projector over and then remove the cover by lifting it up.
  • Flip the projector over and then remove the cover by lifting it up.

Ajouter un commentaire

Remove the three 6mm PH2 phillips head screws. Disconnect the ribbon cable by flipping up the latch on the connector and then pull the ribbon out. Disconnect the ribbon cable by flipping up the latch on the connector and then pull the ribbon out.
  • Remove the three 6mm PH2 phillips head screws.

  • Disconnect the ribbon cable by flipping up the latch on the connector and then pull the ribbon out.

Ajouter un commentaire

Disconnect the three wire connectors.  Grasp both sides of the connector and pull apart. Keep the connector parallel to the mother board to avoid breaking the solder connection. Lift the motherboard up and place it out of the way.
  • Disconnect the three wire connectors. Grasp both sides of the connector and pull apart.

  • Keep the connector parallel to the mother board to avoid breaking the solder connection.

  • Lift the motherboard up and place it out of the way.

Ajouter un commentaire

Remove the five 7mm PH2 phillips head screws on the black plate and lift the plate out. Lift the aluminum heat sink up to remove it from the projector. The motherboard is already removed in this step.
  • Remove the five 7mm PH2 phillips head screws on the black plate and lift the plate out.

  • Lift the aluminum heat sink up to remove it from the projector.

  • The motherboard is already removed in this step.

Ajouter un commentaire

Lift the fan up and out of the projector.
  • Lift the fan up and out of the projector.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

John Russell

Membre depuis le 14/02/2018

747 Réputation

9 tutoriels rédigés

Équipe

USF Tampa, Team S5-G3, Eyestone Spring 2018 Membre de l'équipe USF Tampa, Team S5-G3, Eyestone Spring 2018

USFT-EYESTONE-S18S5G3

3 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 8

30 derniers jours : 19

Total : 34