Ajouter un commentaire

Use Phillips #00 Screwdriver to remove the three screws that hold the upper portion of the access panel. Remove the blade cutter assembly.
  • Use Phillips #00 Screwdriver to remove the three screws that hold the upper portion of the access panel.

  • Remove the blade cutter assembly.

  • Use Phillips #00 Screwdriver to remove the last two screws located in the battery panel that holds the bottom portion of the access panel.

Ajouter un commentaire

Gently remove the access panel from the right side of the device.
  • Gently remove the access panel from the right side of the device.

    • Some electrical wiring will be exposed and will not detach. Be careful not to damage any electrical wiring when removing access panel.

Ajouter un commentaire

Use Phillips #00 Screwdriver to remove three screws that hold down the circuit board. Gently lift the bottom of the circuit board, revealing the keypad.
  • Use Phillips #00 Screwdriver to remove three screws that hold down the circuit board.

  • Gently lift the bottom of the circuit board, revealing the keypad.

    • Be careful not to damage any components on the circuit board when disassembling.

Ajouter un commentaire

Remove the keypad from the front facing cover
  • Remove the keypad from the front facing cover

  • When installing the new keypad, make sure all buttons are correctly set in each hole so that each button can be pressed.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mike Dam

Membre depuis le 25/09/2014

201 Réputation

2 tutoriels rédigés

Équipe

USF Tampa, Team 5-2, Mcgee Fall 2014 Membre de l'équipe USF Tampa, Team 5-2, Mcgee Fall 2014

USFT-MCGEE-F14S5G2

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 6

Total : 441