Introduction

WARNING : Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer.

Here's how to remove and replace the base panel of an Alienware 15 inch laptop. You'll need to remove this panel to access the RAM, solid state disk, and hard disk of the laptop. Additionally, the battery can only disconnected and removed from this location. It is not required that you have a spudger, but it will make disassembly slightly easier.

The information and pictures in this guide have been taken from the service manual from this device, listed on the product page. If you need any additional information on disassembling this device, please consult the service manual.

Pièces

Aucune pièce nécessaire.

  • After turning the computer off, close the display and turn the computer over.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
After the computer base (#1) is facing up, use a Philips screwdriver to remove the two captive screws (#2) which hold the base panel (#3) down.
  • After the computer base (#1) is facing up, use a Philips screwdriver to remove the two captive screws (#2) which hold the base panel (#3) down.

  • Then, use a spudger (#4) to lift up the panel. You can also use your fingernail to lift it as well.

  • After the front has been lifted up a bit, the non-screw side of the panel will need to be slid forward a little to finish lifting out the base panel from the computer.

Ajouter un commentaire

You don't need to disconnect the laptop's battery if you are only replacing the back panel: only perform this step if you will be handling or replacing the electrical components of the computer.
  • You don't need to disconnect the laptop's battery if you are only replacing the back panel: only perform this step if you will be handling or replacing the electrical components of the computer.

  • Disconnect the battery cable from the system board by pulling up on the battery connector (#1).

  • Turn the computer back over and open the display to the point where you can press the power button.

  • Press and hold the power button for 4 seconds to ground the system board so that you can safely remove components such as the RAM.

Ajouter un commentaire

Conclusion

To reassemble the computer, follow these instructions in reverse order and screw on the replacement panel instead of the original panel if a new one is to be used.

William Daniels

Membre depuis le 06/04/2018

666 Réputation

6 tutoriels rédigés

Équipe

Informative Technologies Inc. Membre de l'équipe Informative Technologies Inc.

Community

15 membres

857 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 7

Total : 51