Introduction

Use this guide to replace a damaged display bezel.

Pièces

Aucune pièce nécessaire.

Lay the monitor screen-down so the back screws are exposed.
  • Lay the monitor screen-down so the back screws are exposed.

  • Remove the four 11.9 mm Phillips #2 screws securing the stand to the back of the monitor.

Ajouter un commentaire

Gently lift and pull away the stand at a slight angle away from the monitor.
  • Gently lift and pull away the stand at a slight angle away from the monitor.

Ajouter un commentaire

Locate the two holes on the bottom of the monitor. Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.
  • Locate the two holes on the bottom of the monitor.

  • Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.

  • This task is much easier if two people pry simultaneously at each hole.

  • Continue prying along the entire edge of the monitor.

Ajouter un commentaire

When finished prying, the plastic will partially fall away from the rest of the monitor. Do not try to fully remove the front frame yet. The frame is still attached to the buttons.
  • When finished prying, the plastic will partially fall away from the rest of the monitor.

  • Do not try to fully remove the front frame yet. The frame is still attached to the buttons.

  • While holding the frames together, carefully flip the monitor over so it faces screen down.

  • Gently lift and remove remove the rear case from the monitor.

Ajouter un commentaire

Locate the green interface button board. Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel. Lift the monitor interior away from the front cover.
  • Locate the green interface button board.

  • Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel.

  • Lift the monitor interior away from the front cover.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Mackenzie Keane

Membre depuis le 04/10/2011

475 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 5-36, Amido Fall 2011 Membre de l'équipe Cal Poly, Team 5-36, Amido Fall 2011

CPSU-AMIDO-F11S5G36

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 9

30 derniers jours : 27

Total : 3,172