Introduction

This guide provides step by step instructions to remove your Dell Inspiron 13- 7359 cooling fan. You will need a phillips head #0 screwdriver and a small plastic spudger.

Flip your device over so the back cover is facing you.
  • Flip your device over so the back cover is facing you.

  • Using a Phillips #0 Screwdriver, remove the ten 7mm screws holding the back cover in place.

Ajouter un commentaire

Insert a plastic opening and run it along the edge of the back cover. Do this until the entire back cover can be removed.
  • Insert a plastic opening and run it along the edge of the back cover. Do this until the entire back cover can be removed.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Unscrew and remove the 2 of the 7mm Phillips head screws holding the cooling fan in place. Unscrew and remove the 2 of the 7mm Phillips head screws holding the cooling fan in place.
  • Unscrew and remove the 2 of the 7mm Phillips head screws holding the cooling fan in place.

Ajouter un commentaire

Hold the cooling fan with one hand.
  • Hold the cooling fan with one hand.

  • With the other hand, grab hold of the part of the copper heat sink that is attached to the cooling fan.

  • Carefully pull the cooling fan away from the attached part so that it becomes fully disconnected.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Valentin Medina

Membre depuis le 30/01/2018

437 Réputation

3 tutoriels rédigés

Équipe

Baylor, Team S1-G6, Johnson Spring 2018 Membre de l'équipe Baylor, Team S1-G6, Johnson Spring 2018

BU-JOHNSON-S18S1G6

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 40