Introduction

Before removing the back panel, make sure the device is disconnected from any power source. Make sure that your battery has also been removed.

Use a Phillips #1 screwdriver to remove the two 2.5x8mm screws on the back panel. Use a Phillips #1 screwdriver to remove the two 2.5x8mm screws on the back panel.
  • Use a Phillips #1 screwdriver to remove the two 2.5x8mm screws on the back panel.

Ajouter un commentaire

Kits de RAM Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits de RAM Mac
Obtenez plus de mémoire sur votre Mac.
Place the plastic spudger in the slot. Using the flat side of the spudger pry the back panel upward and off. Do not be afraid to use a bit of muscle, as the panel does not come off without some force.
  • Place the plastic spudger in the slot. Using the flat side of the spudger pry the back panel upward and off.

  • Do not be afraid to use a bit of muscle, as the panel does not come off without some force.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kyla Ward

Membre depuis le 19/03/2018

417 Réputation

4 tutoriels rédigés

Équipe

Baylor, Team S5-G5, Williams Spring 2018 Membre de l'équipe Baylor, Team S5-G5, Williams Spring 2018

BU-WILLIAMS-S18S5G5

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 19

Total : 29