Flip your laptop over to view the bottom and locate the two locks.
  • Flip your laptop over to view the bottom and locate the two locks.

Ajouter un commentaire

Slide the two locks away from each other.
  • Slide the two locks away from each other.

  • Sliding these locks will loosen the battery to allow removal.

Ajouter un commentaire

Pull battery out of the laptop. Your laptop's battery should be completely removed.
  • Pull battery out of the laptop.

  • Your laptop's battery should be completely removed.

Ajouter un commentaire

Flip the laptop right side up.  Open the laptop. Gently press in the four retaining tabs along the top of the keyboard with a spudger, one at a time.
  • Flip the laptop right side up. Open the laptop.

  • Gently press in the four retaining tabs along the top of the keyboard with a spudger, one at a time.

    • After the first tab is released, gently lift up on the keyboard so it doesn't lock again. Finish the other three tabs while gently lifting up on the keyboard. The keyboard will hinge up along the bottom.

Ajouter un commentaire

Gently flip the data cable latch away from the data cable with flat side of spudger. Lift the cable up and out. When reinstalling cable, there are two retainer wings on the sides of the cable that the cable that lock onto the bottom of the cable latch area.  When these are in place the cable is properly inserted.
  • Gently flip the data cable latch away from the data cable with flat side of spudger.

  • Lift the cable up and out.

  • When reinstalling cable, there are two retainer wings on the sides of the cable that the cable that lock onto the bottom of the cable latch area. When these are in place the cable is properly inserted.

  • For removing the optical drive you don't need to disconnect the keyboard ribbon cable.

What do I do is i broke the cable retainer wings and the black thing?

Wezley Joao Ferreira - Réponse

If the connector on the motherboard is still attached and only the clip is broken you can try and find a new clip, or perhaps tape the keyboard in place with electrical tape.

Tyler - Réponse

Close the lid, flip the laptop bottom side up with the battery at the top.
  • Close the lid, flip the laptop bottom side up with the battery at the top.

  • Remove the 11 screws holding the upper case to the lower case.

Ajouter un commentaire

Flip the laptop over and open the lid.
  • Flip the laptop over and open the lid.

  • Remove the two screws from the upper case.

Ajouter un commentaire

Gently unplug the power cable. You lift up on the dark gray latch. Pull the blue ribbon up.
  • Gently unplug the power cable.

    • You lift up on the dark gray latch.

    • Pull the blue ribbon up.

  • Gently unplug the touchpad cable.

    • Lift up on the dark gray latch.

    • Pull the blue ribbon up

Ajouter un commentaire

Grab the metal frame of the upper case and gently pull it away from the lower case. Disconnect the cable that says MB before removing the palmrest.
  • Grab the metal frame of the upper case and gently pull it away from the lower case. Disconnect the cable that says MB before removing the palmrest.

  • Work your way around the perimeter of the upper case.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

7 autre(s) ont terminé cette réparation.

Tyler

Membre depuis le 19/06/2012

3 997 Réputation

18 tutoriels rédigés

Équipe

TechForce Membre de l'équipe TechForce

Business

2 membres

18 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 14

Total : 2,225