Introduction

This guide walks through the steps of locating and removing the WLAN card on your Dell Latitude E4310 Latptop.

Pièces

Aucune pièce nécessaire.

Remove the single Phillips #1 screw. This screw will not necessarily come off of the panel. Lift up and remove with your fingernail, or a spudger, from the side of the door with the screw.
  • Remove the single Phillips #1 screw.

    • This screw will not necessarily come off of the panel.

  • Lift up and remove with your fingernail, or a spudger, from the side of the door with the screw.

Ajouter un commentaire

Remove the single Phillips #1 screw.
  • Remove the single Phillips #1 screw.

Ajouter un commentaire

Use a spudger to pry up the card. Pull the card up and out of its slot. Pull the card up and out of its slot.
  • Use a spudger to pry up the card.

  • Pull the card up and out of its slot.

Ajouter un commentaire

Pull the white and black antenna cables off of the card. Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly. Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly.
  • Pull the white and black antenna cables off of the card.

  • Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brice Brosig

Membre depuis le 21/02/2018

359 Réputation

3 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 10

Total : 47