Pièces

Aucune pièce nécessaire.

Before removing the battery from the laptop, make sure the power is off.
  • Before removing the battery from the laptop, make sure the power is off.

  • Push both battery locking clips outward at the same time.

Ajouter un commentaire

Slide the battery out of the laptop.
  • Slide the battery out of the laptop.

Ajouter un commentaire

Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.
  • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

Ajouter un commentaire

Carefully turn the laptop over and open the screen all the way. Locate the slot to remove the keyboard in the lower left hand corner.
  • Carefully turn the laptop over and open the screen all the way.

  • Locate the slot to remove the keyboard in the lower left hand corner.

  • Using a spudger as a lever, insert it into the slot and gently pry up.

Ajouter un commentaire

After the keyboard pops up, pull it away from the screen just enough to release the tabs.
  • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

  • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

Ajouter un commentaire

Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.
  • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

Ajouter un commentaire

Remove the flexible ribbon from ZIF connector.
  • Remove the flexible ribbon from ZIF connector.

  • Do not pull on the ribbon to remove it from the ZIF connector.

Ajouter un commentaire

Position the laptop so that the bottom is facing upward.
  • Position the laptop so that the bottom is facing upward.

  • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

Ajouter un commentaire

Return the laptop to proper position and open the screen.
  • Return the laptop to proper position and open the screen.

  • Remove the 6 #0 4 mm screws holding in the palm rest.

Ajouter un commentaire

Gently lift the palm rest and rotate it outward so that the bottom is now facing up.
  • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

  • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

Ajouter un commentaire

Lift up on the small ZIF connector and remove ribbon.
  • Lift up on the small ZIF connector and remove ribbon.

  • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

Ajouter un commentaire

Remove the #00 4 mm screws holding the speakers in place.
  • Remove the #00 4 mm screws holding the speakers in place.

Ajouter un commentaire

Gently pull the speaker cable out.
  • Gently pull the speaker cable out.

  • If the wire is tight, wiggle it back and forth but don’t apply too much force.

  • Do not use the speaker wire to pull itself out of the connector.

Ajouter un commentaire

Pull the speakers straight up and out of the laptop.
  • Pull the speakers straight up and out of the laptop.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Elai Fresco

Membre depuis le 20/01/2012

7 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 11-20, Maness Winter 2012 Membre de l'équipe Cal Poly, Team 11-20, Maness Winter 2012

CPSU-MANESS-W12S11G20

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 870