Introduction

Use this guide to replace a damaged front cover or to access the inner parts of the camera.

Pièces

Aucune pièce nécessaire.

Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
  • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

Ajouter un commentaire

On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
  • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

  • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

Ajouter un commentaire

Remove three medium length screws from the bottom of the camera
  • Remove three medium length screws from the bottom of the camera

Ajouter un commentaire

Remove the two medium length screws on the front panel of the camera above the lens mount.
  • Remove the two medium length screws on the front panel of the camera above the lens mount.

  • Once you done, you may use the Spudger to panel from non-grip side.

  • If you start on the grip side, it will be more challenging to loosen the panel.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Daniel Bussone

Membre depuis le 28/01/2011

1 206 Réputation

11 tutoriels rédigés

Équipe

Cal Poly, Team 3-41, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 membres

11 tutoriels rédigés

This should be labelled: Easy.

tjt263 - Réponse

Okay, there are several steps missing.

tjt263 - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 16

30 derniers jours : 40

Total : 4,136