Introduction

This guide will show you how to disassemble the back and side panel of the printer.

Pièces

Aucune pièce nécessaire.

Remove the following two Phillips screws: Two 7.85 mm Phillips #1 screws
  • Remove the following two Phillips screws:

    • Two 7.85 mm Phillips #1 screws

Ajouter un commentaire

Pull the back cover off by lifting up on the cover.
  • Pull the back cover off by lifting up on the cover.

    • You may need to pull firmly as it requires quite a bit of force.

Ajouter un commentaire

Open the front tray.
  • Open the front tray.

Ajouter un commentaire

Lift the scanner compartment.
  • Lift the scanner compartment.

Ajouter un commentaire

After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.
  • After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.

Ajouter un commentaire

Push the blue lever back while twisting it clockwise in order to remove the lever from its slot. After removing the lever, close the scanner compartment and the scanner cover.
  • Push the blue lever back while twisting it clockwise in order to remove the lever from its slot.

  • After removing the lever, close the scanner compartment and the scanner cover.

Ajouter un commentaire

Use the plastic opening tool to pry open the side cover. Use the plastic opening tool to pry open the side cover.
  • Use the plastic opening tool to pry open the side cover.

Ajouter un commentaire

Flip the printer so that you are facing the underside. Use the plastic opening tool to remove the corner of the side panel from the pin.
  • Flip the printer so that you are facing the underside.

  • Use the plastic opening tool to remove the corner of the side panel from the pin.

    • Plastic pin.

Ajouter un commentaire

Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer. Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.
  • Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Kevin Cole

Membre depuis le 17/01/2013

98 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 19-41, Regan Winter 2013 Membre de l'équipe Cal Poly, Team 19-41, Regan Winter 2013

CPSU-REGAN-W13S19G41

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 18

30 derniers jours : 121

Total : 12,673