Introduction

Remove the back cover before removing LCD display.

Pièces

Aucune pièce nécessaire.

Remove one 2.25mm screw on the bottom.
  • Remove one 2.25mm screw on the bottom.

Ajouter un commentaire

Remove two 2.25mm screws on the right side looking from the front.
  • Remove two 2.25mm screws on the right side looking from the front.

Ajouter un commentaire

Remove one 4.7mm screw on the side with the AV output.
  • Remove one 4.7mm screw on the side with the AV output.

Ajouter un commentaire

Pull off the back cover.
  • Pull off the back cover.

  • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

Ajouter un commentaire

Remove 2 2.4mm screws on bottom.
  • Remove 2 2.4mm screws on bottom.

Ajouter un commentaire

Follow the small data cable to where it connects to the camera.
  • Follow the small data cable to where it connects to the camera.

  • Lift the back white portion to unlock the cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

Ajouter un commentaire

Gently lift LCD display off.
  • Gently lift LCD display off.

  • There will be two data cables still attached to the camera. Do not break them.

  • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

Ajouter un commentaire

Follow the larger cable to where it connects to the camera.
  • Follow the larger cable to where it connects to the camera.

  • Lift the front black portion of the connector to unlock the data cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

Ajouter un commentaire

Pry the LCD display out from the four metal clamps.
  • Pry the LCD display out from the four metal clamps.

Ajouter un commentaire

To remove the LCD, peel the larger data cable off from the frame.
  • To remove the LCD, peel the larger data cable off from the frame.

  • The LCD is glued by its data cable to the back of the LCD frame.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Membre depuis le 10/10/2010

135 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 20-9, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 6

Total : 2,493