Introduction

The Macintosh IIsi has a case fan mouted on inside back of the computer case.

The fan recieves power from two contacts on the logic board and has no connector.
  • The fan recieves power from two contacts on the logic board and has no connector.

Ajouter un commentaire

In all of the years that I have worked on this machine, I have found no good way to remove the fan. The best way to start, is to push in here on the side of the fan. Being careful not to exert too much force, try to push in, and wiggle the fan outward as such. (2nd Photo)
  • In all of the years that I have worked on this machine, I have found no good way to remove the fan.

  • The best way to start, is to push in here on the side of the fan.

  • Being careful not to exert too much force, try to push in, and wiggle the fan outward as such. (2nd Photo)

  • You can now lift the fan all the way out, and remove it.

  • The Fan Power Contacts on the Logic Board:

There is no need to pull out the fan. Just take a knife and you can squeeze the tab in step 7

Willy Kaiser - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Chris Green

Membre depuis le 11/10/2009

31 418 Réputation

46 tutoriels rédigés

Équipe

Master Techs Membre de l'équipe Master Techs

Community

274 membres

713 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 3

Total : 1,559