Pièces

Aucune pièce nécessaire.

Flip over the turntable and remove the nine screws on the outer edges. Flip over the turntable and remove the nine screws on the outer edges.
  • Flip over the turntable and remove the nine screws on the outer edges.

Ajouter un commentaire

Remove the back cover by pulling it apart.
  • Remove the back cover by pulling it apart.

Ajouter un commentaire

Locate the largest circuit board inside the device.
  • Locate the largest circuit board inside the device.

Ajouter un commentaire

Locate the wires that are plugged into the side of the circuit board.
  • Locate the wires that are plugged into the side of the circuit board.

Ajouter un commentaire

Gently pull out the wires plugged into the circuit board. Gently pull out the wires plugged into the circuit board.
  • Gently pull out the wires plugged into the circuit board.

Ajouter un commentaire

Once the wires are unplugged you will notice two more wires plugged into the bottom of the circuit board. Note that these wires are soldered onto the circuit, indicated by the red markers.
  • Once the wires are unplugged you will notice two more wires plugged into the bottom of the circuit board.

  • Note that these wires are soldered onto the circuit, indicated by the red markers.

  • To completely remove the circuit board these wires must be removed.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sukhjinder

Membre depuis le 12/10/2011

11 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 17-14, Regan Fall 2011 Membre de l'équipe Cal Poly, Team 17-14, Regan Fall 2011

CPSU-REGAN-F11S17G14

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 6

30 derniers jours : 12

Total : 936