Pièces

Aucune pièce nécessaire.

Remove the 2 screws on the back cover using a Phillips head #0 screwdriver. Remove the 2 screws on the back cover using a Phillips head #0 screwdriver.
  • Remove the 2 screws on the back cover using a Phillips head #0 screwdriver.

Ajouter un commentaire

Remove the screw on each side of the device using a Phillips head screwdriver. Remove the screw on each side of the device using a Phillips head screwdriver.
  • Remove the screw on each side of the device using a Phillips head screwdriver.

Ajouter un commentaire

Using the plastic opening kit, place the prying end of the kit into the opening created by removing the screws. Gently pry open the back cover. Insert the plastic opening tool in between the cover joints. Gently pry open the back cover. Insert the plastic opening tool in between the cover joints.
  • Using the plastic opening kit, place the prying end of the kit into the opening created by removing the screws.

  • Gently pry open the back cover. Insert the plastic opening tool in between the cover joints.

Ajouter un commentaire

Using the philips screwdriver, remove the two screws on the mother board. Using the philips screwdriver, remove the two screws on the mother board.
  • Using the philips screwdriver, remove the two screws on the mother board.

Ajouter un commentaire

Place the pry tool in-between the front cover and mother board. Gently separate the front cover. Gently separate the front cover.
  • Place the pry tool in-between the front cover and mother board.

  • Gently separate the front cover.

Ajouter un commentaire

After opening the front cover you will see and electric ribbon connecting the buttons to the mother board.
  • After opening the front cover you will see and electric ribbon connecting the buttons to the mother board.

Ajouter un commentaire

CAUTION: Do not rip the electric ribbon from the mother board. Carefully flip up the plastic lip that holds the electric ribbon to the board.
  • CAUTION: Do not rip the electric ribbon from the mother board.

  • Carefully flip up the plastic lip that holds the electric ribbon to the board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jason Farr

Membre depuis le 21/10/2013

337 Réputation

3 tutoriels rédigés

Équipe

Clemson, Team 14-8, Benson Fall 2013 Membre de l'équipe Clemson, Team 14-8, Benson Fall 2013

CLEM-BENSON-F13S14G8

3 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 4

30 derniers jours : 5

Total : 138