Pièces

Aucune pièce nécessaire.

Unscrew these #1 Philips screws, and leave them in the plastic foot holders.
  • Unscrew these #1 Philips screws, and leave them in the plastic foot holders.

Ajouter un commentaire

Remove the foot holders and place them on the side
  • Remove the foot holders and place them on the side

Ajouter un commentaire

Remove the four feet and place them on the side
  • Remove the four feet and place them on the side

Ajouter un commentaire

Remove these #1 Philips screws, and leave them in their counterbores
  • Remove these #1 Philips screws, and leave them in their counterbores

Ajouter un commentaire

Lift grey shell off and place to the side to reveal:
  • Lift grey shell off and place to the side to reveal:

  • ADC and Logic board

  • Bluetooth module

  • Strain gauges

  • Battery holder

Ajouter un commentaire

The ADC and Logic board contains:
  • The ADC and Logic board contains:

  • Bluetooth module

  • Power button connector

  • Battery and sync button connector

  • Strain gauge wheatstone bridge connections

    • The topmost connection for each of the four bridge connections is the ground; relative to this, the two middle connections should be at 1.2 VDC, and the bottom should be at 2.7 VDC

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

10 autre(s) ont terminé cette réparation.

Pete Marchetto

Membre depuis le 25/01/2011

421 Réputation

1 tutoriel rédigé

Great stuff Pete, being able to fix the wifi board got me mucho street cred with " her indoors " and lots of other goodies that go along with that

HENRY - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 19

30 derniers jours : 65

Total : 7,553