Introduction

This guide walks through the process of replacing the camera. For safety reasons, you must first follow instructions to remove the battery. After the battery is disconnected, you can follow the rest of the directions to safely remove the camera.

Insert the plastic opening tool between the white back cover and black front over.
  • Insert the plastic opening tool between the white back cover and black front over.

Ajouter un commentaire

Slide the plastic opening tool along the edgeof the device until back cover is detached and remove the cover. You may need to pry the back cover off using the opening tool while moving it along the edge.
  • Slide the plastic opening tool along the edgeof the device until back cover is detached and remove the cover.

  • You may need to pry the back cover off using the opening tool while moving it along the edge.

Ajouter un commentaire

Remove the yellow tape holding the battery to the device using your fingers or plastic opening tool if necessary.
  • Remove the yellow tape holding the battery to the device using your fingers or plastic opening tool if necessary.

Ajouter un commentaire

Use the hair dryer to melt the glue holding the battery to the device.
  • Use the hair dryer to melt the glue holding the battery to the device.

  • Be careful not to overheat the battery as it could cause the battery to combust.

Ajouter un commentaire

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Insert the plastic card under the battery and use it to remove the battery from the device.
  • Insert the plastic card under the battery and use it to remove the battery from the device.

  • Be careful not to deform the battery.

Ajouter un commentaire

Desolder the red and black wires connecting the battery to the motherboard and remove the battery. Desolder the red and black wires connecting the battery to the motherboard and remove the battery.
  • Desolder the red and black wires connecting the battery to the motherboard and remove the battery.

Ajouter un commentaire

Remove black tape holding the cameras to the motherboard. Remove black tape holding the cameras to the motherboard.
  • Remove black tape holding the cameras to the motherboard.

Ajouter un commentaire

Use your fingernail to flip up the small locking flap on the ZIF connector. Pull the ribbon cable from the ZIF connector.
  • Use your fingernail to flip up the small locking flap on the ZIF connector.

  • Pull the ribbon cable from the ZIF connector.

Ajouter un commentaire

Remove the front camera from the device using your fingers.
  • Remove the front camera from the device using your fingers.

Ajouter un commentaire

Melt the glue holding the rear camera in place using a hair dryer. Insert the metal spludger under the rear camera and pry it free from the device.
  • Melt the glue holding the rear camera in place using a hair dryer.

  • Insert the metal spludger under the rear camera and pry it free from the device.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Josh Null

Membre depuis le 21/03/2018

313 Réputation

3 tutoriels rédigés

Équipe

IUPUI, Team S5-G5, Baechle Spring 2018 Membre de l'équipe IUPUI, Team S5-G5, Baechle Spring 2018

IUPUI-BAECHLE-S18S5G5

3 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 5

Total : 14