Introduction

When fishing, it is very easy for a bigger catch to over power the fisher and break their line. This guide serves to show how one can restring a fishing line after it has been snapped. The only special requirement this guide needs is that the spool must still be intact and functioning correctly.

Outils

Aucun outil requis.

Thread fishing line through all eyelets on the fishing pole.
  • Thread fishing line through all eyelets on the fishing pole.

Ajouter un commentaire

At the top of the allotted seven to ten feet, thread the line through one hook of the bobber by depressing the opposite side of the bobber so that the hook is exposed.
  • At the top of the allotted seven to ten feet, thread the line through one hook of the bobber by depressing the opposite side of the bobber so that the hook is exposed.

Ajouter un commentaire

Repeat step two for the opposite end of the bobber, threading the line through the second hook.
  • Repeat step two for the opposite end of the bobber, threading the line through the second hook.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
About one to two feet before the end of the line, thread a weight onto the line.
  • About one to two feet before the end of the line, thread a weight onto the line.

Ajouter un commentaire

Tie a knot around the weight's eyelet. (No specific knot needed, it just needs to stay in place.)
  • Tie a knot around the weight's eyelet. (No specific knot needed, it just needs to stay in place.)

Ajouter un commentaire

At the very end of the line, thread the line through the eyelet of the lure about 6 inches.
  • At the very end of the line, thread the line through the eyelet of the lure about 6 inches.

Ajouter un commentaire

Twist the line around itself approximately five to six times.
  • Twist the line around itself approximately five to six times.

Ajouter un commentaire

Thread the remaining line through the hole created by the previous step near the lure eyelet.
  • Thread the remaining line through the hole created by the previous step near the lure eyelet.

Ajouter un commentaire

Pull the knot tight.
  • Pull the knot tight.

Ajouter un commentaire

Conclusion

After step 9 you are ready to fish.

Trevone Martin

Membre depuis le 22/02/2018

169 Réputation

1 tutoriel rédigé

Équipe

This is Joe from Durban Deep Sea Fishing Charters. This is a short and concise but very helpful guide to replace a fishing line. I will be sure to share this with my clients. Thanks guys

Joe Osborne - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 23