Introduction

Use this repair guide in order to replace the speakers.

Take the battery cover off by releasing the locking tab and hinging the cover away. Take the battery cover off by releasing the locking tab and hinging the cover away. Take the battery cover off by releasing the locking tab and hinging the cover away.
  • Take the battery cover off by releasing the locking tab and hinging the cover away.

Ajouter un commentaire

Remove the six back panel screws using a Tri-wing Screwdriver.
  • Remove the six back panel screws using a Tri-wing Screwdriver.

Ajouter un commentaire

Remove bottom back panel screw with a Phillips #1 screw driver.
  • Remove bottom back panel screw with a Phillips #1 screw driver.

We recommend you change the the screw head to a Phillips 1 so you don't strip the screw. (Something we experienced)

Adriano Agostino - Réponse

Remove the back panel by pulling away with one hand and the front secured in the other hand.
  • Remove the back panel by pulling away with one hand and the front secured in the other hand.

  • Removal of the back panel may cause shoulder buttons and side panels to come loose and fall off.

Ajouter un commentaire

Remove left and right triggers by lifting and pulling them away from the system. Do the same for side panels
  • Remove left and right triggers by lifting and pulling them away from the system.

  • Do the same for side panels

  • For finicky or jammed triggers only. Adjust and correct triggers and reassemble. Most jammed triggers are caused by buttons misplaced or jammed in its enclosure.

Ajouter un commentaire

Remove the gray On/Off Switch by pulling up and away from the unit. Replace with another switch if necessary.
  • Remove the gray On/Off Switch by pulling up and away from the unit. Replace with another switch if necessary.

Ajouter un commentaire

Remove the rubber button pads from their pockets. Remove the plastic buttons and the D-pad from beneath the rubber pads with tweezers or by hand. Remove the plastic buttons and the D-pad from beneath the rubber pads with tweezers or by hand.
  • Remove the rubber button pads from their pockets.

  • Remove the plastic buttons and the D-pad from beneath the rubber pads with tweezers or by hand.

Ajouter un commentaire

Using the tweezers, gently pull the ribbon from the logic board. Using the tweezers, gently pull the ribbon from the logic board. Using the tweezers, gently pull the ribbon from the logic board.
  • Using the tweezers, gently pull the ribbon from the logic board.

Ajouter un commentaire

Slightly move the speaker to the right and desolder the two wires from the logic board. Beware of over heating the soldering kit will damage the logic board. Beware of over heating the soldering kit will damage the logic board.
  • Slightly move the speaker to the right and desolder the two wires from the logic board.

  • Beware of over heating the soldering kit will damage the logic board.

Ajouter un commentaire

Ligne d'arrivée

7 autre(s) ont terminé cette réparation.

Adam

Membre depuis le 20/01/2010

620 Réputation

10 tutoriels rédigés

Équipe

Cal Poly, Team 16-29, Maness Winter 2010 Membre de l'équipe Cal Poly, Team 16-29, Maness Winter 2010

CPSU-MANESS-W10S16G29

5 membres

26 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 15

30 derniers jours : 62

Total : 7,252