Introduction

In this guide there are delicate parts that will very easily break under tension. Keep this in mind as your move forwards.

Pièces

Aucune pièce nécessaire.

Remove the six T5 Torx 6.32mm screws securing the back cover to the watch. Remove the six T5 Torx 6.32mm screws securing the back cover to the watch.
  • Remove the six T5 Torx 6.32mm screws securing the back cover to the watch.

Ajouter un commentaire

Remove the back cover carefully.
  • Remove the back cover carefully.

  • Even after the screws have been removed, the back cover can still be quite difficult to take off. Moderate to extensive prying may be required. Be gentle, but firm.

Ajouter un commentaire

Remove the orange gasket.
  • Remove the orange gasket.

Ajouter un commentaire

Remove the screen and motherboard assembly from the case.
  • Remove the screen and motherboard assembly from the case.

Ajouter un commentaire

Use a metal spudger to remove the golden retaining clip from the screen. There will be some adhesive to break.
  • Use a metal spudger to remove the golden retaining clip from the screen. There will be some adhesive to break.

Ajouter un commentaire

Remove the screen from the golden metal clip.
  • Remove the screen from the golden metal clip.

Ajouter un commentaire

Unhinge the black retaining hinge by prying it open with the metal spudger; Your fingernails will work as well.
  • Unhinge the black retaining hinge by prying it open with the metal spudger; Your fingernails will work as well.

Ajouter un commentaire

Remove the connector from the motherboard by pulling it free at the base. Make sure to pull from the base of the connector wire, as it is very easy to rip the wire from the screen.
  • Remove the connector from the motherboard by pulling it free at the base.

  • Make sure to pull from the base of the connector wire, as it is very easy to rip the wire from the screen.

Ajouter un commentaire

Remove the screen from the motherboard.
  • Remove the screen from the motherboard.

  • Notice our tape retaining the connector to the screen. This is so easy to rip!

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Evan Miller

Membre depuis le 21/03/2018

205 Réputation

2 tutoriels rédigés

Équipe

IUPUI, Team S4-G1, Baechle Spring 2018 Membre de l'équipe IUPUI, Team S4-G1, Baechle Spring 2018

IUPUI-BAECHLE-S18S4G1

3 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 18

Total : 27