Introduction

Removing the logic board from the Garmin Nuvi 200

Peel off the sticker from the bottom of the device to reveal two screws. Peel off the sticker from the bottom of the device to reveal two screws.
  • Peel off the sticker from the bottom of the device to reveal two screws.

Ajouter un commentaire

Remove two T5 Torx screws.
  • Remove two T5 Torx screws.

Ajouter un commentaire

Insert a plastic opening tool in the gap between the front and rear casing. Carefully work the tool around the gap, separating the two halves of the case.
  • Insert a plastic opening tool in the gap between the front and rear casing.

  • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

Ajouter un commentaire

Peel away the tape holding the ribbon cable in place.
  • Peel away the tape holding the ribbon cable in place.

  • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

Ajouter un commentaire

Pull out the cable between the logic board and the speaker to disconnect them.
  • Pull out the cable between the logic board and the speaker to disconnect them.

Ajouter un commentaire

Remove the three screws from the logic board using the #00 Phillips screwdriver. Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.
  • Remove the three screws from the logic board using the #00 Phillips screwdriver.

  • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

Ajouter un commentaire

Detach the logic board form the battery by pulling out the cable. Detach the logic board form the battery by pulling out the cable.
  • Detach the logic board form the battery by pulling out the cable.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Anjelica

Membre depuis le 11/04/2010

504 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 25-90, Amido Spring 2010 Membre de l'équipe Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 5

30 derniers jours : 28

Total : 9,488