Introduction

The hard drive is the main storage unit of the laptop. It is the component that stores all of the data of the device. This guide will show the proper removal of the laptop's hard drive.

Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
  • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

Ajouter un commentaire

Use a Torx T5 head to remove the six 5.1 mm screws. Use a JIS J1 to remove the two 7.2mm screws. Use a JIS J1 to remove the two 7.2mm screws.
  • Use a Torx T5 head to remove the six 5.1 mm screws.

  • Use a JIS J1 to remove the two 7.2mm screws.

Ajouter un commentaire

Use Plastic opening tool to pry open the case. Go slowly around the edge.  You will hear popping noises, such are due to popping open the small joints that keep the cover attached.
  • Use Plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Use a J1 to remove the six 4.7 mm screws. Use a J1 to remove the six 4.7 mm screws.
  • Use a J1 to remove the six 4.7 mm screws.

Ajouter un commentaire

Battery might cause a small electric shock.
  • Battery might cause a small electric shock.

  • Use tweezers to disconnect the battery from the motherboard.

Ajouter un commentaire

Use a JIS J1 bit to remove the two 4.6 mm screws. Use a JIS J1 bit to remove the two 4.6 mm screws.
  • Use a JIS J1 bit to remove the two 4.6 mm screws.

Ajouter un commentaire

The red square is around the ribbon cable. Use the plastic opening tool to open the black security connector. then pull the ribbon cable to disconnect it from the motherboard.
  • The red square is around the ribbon cable.

  • Use the plastic opening tool to open the black security connector. then pull the ribbon cable to disconnect it from the motherboard.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Matthew Martin

Membre depuis le 10/10/2017

501 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S13-G17, Cagle Fall 2017 Membre de l'équipe USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 7

7 derniers jours : 54

30 derniers jours : 297

Total : 1,050