Introduction

In order for constant shut downs to persist the hard drive will need to be replaced. At times hard drives installed incorrectly could be the issue and in that case it may not be necessary to completely replace rather to reinstall.

The only tools needed is a Positive PH0 screwdriver.

Pièces

Aucune pièce nécessaire.

Place the laptop upside down where the headphone and auxiliary jack are facing you.
  • Place the laptop upside down where the headphone and auxiliary jack are facing you.

Ajouter un commentaire

In the top left corner, there is a lever that has a small picture of a battery on it.  Slide the lever to the left.
  • In the top left corner, there is a lever that has a small picture of a battery on it. Slide the lever to the left.

Ajouter un commentaire

Once you have slid the lever to the left, the front part of the battery will be released and you should be able to grab the released part of the battery with your thumb.
  • Once you have slid the lever to the left, the front part of the battery will be released and you should be able to grab the released part of the battery with your thumb.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
The battery can then be pulled out of its compartment by hand.
  • The battery can then be pulled out of its compartment by hand.

Ajouter un commentaire

Once the battery has been removed, locate the 5mm Phillips #0 screws on the bottom right panel.
  • Once the battery has been removed, locate the 5mm Phillips #0 screws on the bottom right panel.

  • Remove the 5mm Phillips #0 screws using the Phillips #0 Screwdriver.

  • Next, remove the panel that was attached to the screws, leaving the hard drive exposed.

Ajouter un commentaire

After the panel has been removed, use the screwdriver to remove the three 3mm Phillips #0 screws attached to the hard drive.
  • After the panel has been removed, use the screwdriver to remove the three 3mm Phillips #0 screws attached to the hard drive.

Ajouter un commentaire

Once the screws attached to the hard drive are removed, you will be able to take the hard drive out of the compartment.
  • Once the screws attached to the hard drive are removed, you will be able to take the hard drive out of the compartment.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Larissa Moreno-Trejo

Membre depuis le 07/11/2017

101 Réputation

1 tutoriel rédigé

Équipe

Baylor, Team S8-G7, Johnson Fall 2017 Membre de l'équipe Baylor, Team S8-G7, Johnson Fall 2017

BU-JOHNSON-F17S8G7

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 6

Total : 59