Introduction

This guide instructs you how to remove the RAM. You will need the screwdriver listed in the tools section.

Pièces

Aucune pièce nécessaire.

Step 1 – Battery: Locate the battery release slider on the bottom of the laptop and move it in the direction of the arrow to the unlock position.
  • Step 1 – Battery: Locate the battery release slider on the bottom of the laptop and move it in the direction of the arrow to the unlock position.

  • The yellow highlighted edge of the battery should pop up slightly when the switch is moved

Ajouter un commentaire

Step 2: Using the edge of the battery that has popped up, lift the battery out of the computer. Step 2: Using the edge of the battery that has popped up, lift the battery out of the computer.
  • Step 2: Using the edge of the battery that has popped up, lift the battery out of the computer.

Ajouter un commentaire

Remove the two 3.5 mm diameter head and 7 mm long screws using the Philips PH1 screwdriver. Both screws will remain attached to the cover. Set the cover with attached screws to the side.
  • Remove the two 3.5 mm diameter head and 7 mm long screws using the Philips PH1 screwdriver.

  • Both screws will remain attached to the cover.

  • Set the cover with attached screws to the side.

  • The RAM will now be exposed

Ajouter un commentaire

Find the two clips located on each side of the RAM. Using both hands, simultaneously grab each clip and open them away from the RAM stick. The RAM will pop up.
  • Find the two clips located on each side of the RAM.

  • Using both hands, simultaneously grab each clip and open them away from the RAM stick.

  • The RAM will pop up.

Ajouter un commentaire

Using one hand, pull the RAM up and to the left to remove it. Using one hand, pull the RAM up and to the left to remove it.
  • Using one hand, pull the RAM up and to the left to remove it.

Ajouter un commentaire

If there is a second RAM module present (as shown), repeat steps 2 and 3 to remove it.
  • If there is a second RAM module present (as shown), repeat steps 2 and 3 to remove it.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Brandon Baldovin

Membre depuis le 30/09/2013

482 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 14-10, Forte Fall 2013 Membre de l'équipe Cal Poly, Team 14-10, Forte Fall 2013

CPSU-FORTE-F13S14G10

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 12

Total : 1,436