Introduction

Is your computer running slow? One cause could be an insufficient amount of RAM. By following this guide below, you can upgrade the RAM in your HP Pavilion dv6-6117dx to help give your computer a breath of fresh air.

Pièces

Aucune pièce nécessaire.

Begin removing the bottom cover by sliding the battery removal slider to the right to pop off the top of the cover. Begin removing the bottom cover by sliding the battery removal slider to the right to pop off the top of the cover.
  • Begin removing the bottom cover by sliding the battery removal slider to the right to pop off the top of the cover.

Ajouter un commentaire

Slide a black spudger under the top of the cover to loosen the clips underneath. Slide a black spudger under the top of the cover to loosen the clips underneath.
  • Slide a black spudger under the top of the cover to loosen the clips underneath.

Ajouter un commentaire

Slide the spudger down the left side of the cover to loosen the clips. After the left side is loose, the rest of the cover should pop off, and you can remove it with your hands. When reassembling, insert the bottom of the cover first, and then firmly press along the edges from bottom to top to secure it in place.
  • Slide the spudger down the left side of the cover to loosen the clips.

  • After the left side is loose, the rest of the cover should pop off, and you can remove it with your hands.

  • When reassembling, insert the bottom of the cover first, and then firmly press along the edges from bottom to top to secure it in place.

Ajouter un commentaire

Push the tabs on both sides away from each other to free the RAM, which will raise to a 45º angle. Push the tabs on both sides away from each other to free the RAM, which will raise to a 45º angle.
  • Push the tabs on both sides away from each other to free the RAM, which will raise to a 45º angle.

Ajouter un commentaire

Always handle RAM by the edges to avoid damaging the part. Remove the RAM by grabbing it by the sides and pulling out at a 45º angle.
  • Always handle RAM by the edges to avoid damaging the part.

  • Remove the RAM by grabbing it by the sides and pulling out at a 45º angle.

  • When inserting the new stick of RAM, you should insert it at this same angle.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Joshua Holme

Membre depuis le 19/03/2018

591 Réputation

4 tutoriels rédigés

Équipe

UMass Dartmouth, Team S6-G3, Bernier Spring 2018 Membre de l'équipe UMass Dartmouth, Team S6-G3, Bernier Spring 2018

UMASSD-BERNIER-S18S6G3

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 4

Total : 34