Introduction

Replace the optical drive assembly in your HP Pavilion dv6000.

Pièces

Aucune pièce nécessaire.

Before proceeding, it is recommended to remove the battery to prevent any electrical damage to components.
  • Before proceeding, it is recommended to remove the battery to prevent any electrical damage to components.

  • Remove the single 5.6 mm Phillips screw securing the optical drive to the lower case.

Ajouter un commentaire

Insert the tip of an unrolled paper clip into the small hole located on the side of the optical drive.
  • Insert the tip of an unrolled paper clip into the small hole located on the side of the optical drive.

  • The tray will partially pop out of the laptop.

  • Firmly pull the drive straight away from the laptop.

  • While pulling the drive out, be careful not to bend the sliding rails on both sides of the optical drive.

  • At this point you can remove the entire optical drive, or you can continue to disassemble the optical drive assembly.

Ajouter un commentaire

Remove the three 3.2 mm screws securing the top plate of the optical drive. Lift and remove the top plate up off the optical drive.
  • Remove the three 3.2 mm screws securing the top plate of the optical drive.

  • Lift and remove the top plate up off the optical drive.

Ajouter un commentaire

Lift and remove the optical drive assembly.
  • Lift and remove the optical drive assembly.

  • It may be helpful to gently "rock" the drive assembly side to side to dislodge it from its recess.

  • For the rest of the guide, be careful to not touch any of the circuitry on the board as well as the laser lens!

Ajouter un commentaire

Flip the drive over.
  • Flip the drive over.

  • Pull the small ribbon cable straight away from its socket on the optical drive assembly board.

Ajouter un commentaire

Use your fingernail to flip up the cable retaining flap on the ZIF socket for the larger ribbon cable.
  • Use your fingernail to flip up the cable retaining flap on the ZIF socket for the larger ribbon cable.

  • Pull the larger ribbon cable straight out of its socket on the optical drive assembly board.

Ajouter un commentaire

Lift and remove the optical drive assembly from the optical drive framework.
  • Lift and remove the optical drive assembly from the optical drive framework.

  • Optical drive assembly remains.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ben Hirsch

Membre depuis le 05/10/2010

3 538 Réputation

10 tutoriels rédigés

Équipe

Cal Poly, Team 21-33, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 21-33, Regan Fall 2010

CPSU-REGAN-F10S21G33

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 4

30 derniers jours : 11

Total : 6,314