Introduction

The speakers are relatively easy to remove. There are no screws. All you need to do is disconnect a wire and pull.

Slide pill shaped tab to the other side of the channel.
  • Slide pill shaped tab to the other side of the channel.

Ajouter un commentaire

  • Remove battery while keeping the tab to the side.

Ajouter un commentaire

Unscrew the two screws JIS #0 located on opposites sides of the panel.
  • Unscrew the two screws JIS #0 located on opposites sides of the panel.

  • Screws are attached to the panel and will not fully come out.

Ajouter un commentaire

Carefully pry off the L-shaped panel.
  • Carefully pry off the L-shaped panel.

Ajouter un commentaire

Idées cadeaux pour la Fête des Pères
Mettons nos papas à l’honneur ainsi que nos mentors qui nous ont appris à réparer.
Idées cadeaux pour la Fête des Pères
Honorons ceux qui nous ont enseigné à réparer.
Pull out and unplug the tab on the right hand side.
  • Pull out and unplug the tab on the right hand side.

Ajouter un commentaire

Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.
  • Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.

Ajouter un commentaire

Remove 3 screws located where the battery previously was.
  • Remove 3 screws located where the battery previously was.

Ajouter un commentaire

Remove 6 screws located under the spot where the smaller L-shaped panel was located. Remove 6 screws located under the spot where the smaller L-shaped panel was located.
  • Remove 6 screws located under the spot where the smaller L-shaped panel was located.

Ajouter un commentaire

Slowly pry off the keyboard from the back panel.
  • Slowly pry off the keyboard from the back panel.

  • Between the back panel and the keyboard there are two ribbon wires.

  • Remove slowly to not break the back panel. If it does not come off easily, check to see if all screws are removed.

Ajouter un commentaire

Unplug wires connecting back panel to keyboard.
  • Unplug wires connecting back panel to keyboard.

Ajouter un commentaire

Unplug the red and white wires. Unplug the red and white wires.
  • Unplug the red and white wires.

Ajouter un commentaire

Remove the speakers.
  • Remove the speakers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Robert Hamilton

Membre depuis le 01/03/2018

1 051 Réputation

10 tutoriels rédigés

Équipe

UMass Dartmouth, Team S2-G7, Simcock Spring 2018 Membre de l'équipe UMass Dartmouth, Team S2-G7, Simcock Spring 2018

UMASSD-SIMCOCK-S18S2G7

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 9

Total : 24