Introduction

This guide will explain how to replace the keyboard of the device. The process should be rather simplistic but proceed with caution since some parts of the device are fragile.

Pièces

Aucune pièce nécessaire.

Remove the two  5mm Phillips #0 screws from the hinges Remove the two  5mm Phillips #0 screws from the hinges Remove the two  5mm Phillips #0 screws from the hinges
  • Remove the two 5mm Phillips #0 screws from the hinges

Ajouter un commentaire

Open the device as if you were going to use the device. Using Tweezers, pry the hinges from underneath the screen Not much force is needed to pull the hinges off once the tweezers are properly positioned
  • Open the device as if you were going to use the device. Using Tweezers, pry the hinges from underneath the screen

  • Not much force is needed to pull the hinges off once the tweezers are properly positioned

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Remove the wire connection by gently pulling  on the fuse and connection itself. Do not pull on the wires, as this can remove the wires from the connection, destroying the fuse.
  • Remove the wire connection by gently pulling on the fuse and connection itself.

  • Do not pull on the wires, as this can remove the wires from the connection, destroying the fuse.

Ajouter un commentaire

Remove the four 4.0 mm Phillips #0 connecting the keyboard to the frame Remove the four 4.0 mm Phillips #0 connecting the keyboard to the frame Remove the four 4.0 mm Phillips #0 connecting the keyboard to the frame
  • Remove the four 4.0 mm Phillips #0 connecting the keyboard to the frame

Ajouter un commentaire

Gently lift the keyboard up from the frame so that you can see the  ribbon  still connected. Gently lift the keyboard up from the frame so that you can see the  ribbon  still connected.
  • Gently lift the keyboard up from the frame so that you can see the ribbon still connected.

Ajouter un commentaire

Remove the ribbon by  gently  pulling up the ends of the white receiver it is inserted in to. You may need to use tweezers for this part. During reassembly, when inserting the ribbon, you will hear a quiet, clicking sound when pushing down on the ends of the receiver.  Hearing this ensures the ribbon is in place.
  • Remove the ribbon by gently pulling up the ends of the white receiver it is inserted in to.

  • You may need to use tweezers for this part.

  • During reassembly, when inserting the ribbon, you will hear a quiet, clicking sound when pushing down on the ends of the receiver. Hearing this ensures the ribbon is in place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order starting at step 5.

Eric Beaudry

Membre depuis le 06/03/2018

727 Réputation

3 tutoriels rédigés

Équipe

UMass Dartmouth, Team S2-G7, Bernier Spring 2018 Membre de l'équipe UMass Dartmouth, Team S2-G7, Bernier Spring 2018

UMASSD-BERNIER-S18S2G7

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 26