Pièces

Aucune pièce nécessaire.

Open the printer's mouth by pulling the two mouth pieces down.
  • Open the printer's mouth by pulling the two mouth pieces down.

  • Lift the flap covering the scanner. When you are finished, the printer should appear as shown.

Ajouter un commentaire

Remove the flap for the scanner by pulling lightly on the clip that attaches it to the printer.
  • Remove the flap for the scanner by pulling lightly on the clip that attaches it to the printer.

  • The clip may be damaged by applying too much force.

Ajouter un commentaire

Remove the three screws from the top of the printer using a T9 screwdriver as shown. The screws are located in the far-left, far-right, and near-right corners of the printer, with respect to the front view. The screws are located in the far-left, far-right, and near-right corners of the printer, with respect to the front view.
  • Remove the three screws from the top of the printer using a T9 screwdriver as shown.

  • The screws are located in the far-left, far-right, and near-right corners of the printer, with respect to the front view.

Ajouter un commentaire

Reach into the mouth of the printer and press the clip behind the power button to release the power button face.
  • Reach into the mouth of the printer and press the clip behind the power button to release the power button face.

Ajouter un commentaire

A picture of the removed power button is provided to show the location of the clip that needs to be pressed.
  • A picture of the removed power button is provided to show the location of the clip that needs to be pressed.

  • After pressing the clip, pull out the face of the power button by sliding it from the right to the left side.

Ajouter un commentaire

The power button face has a plastic holder that attaches the power button  and the wireless button to the face plate using two slots. Loosen the plastic holder by pulling the slots on the face plate away from the plastic holder. Remove the plastic holder from the face plate after the slots are loosened.
  • The power button face has a plastic holder that attaches the power button and the wireless button to the face plate using two slots.

  • Loosen the plastic holder by pulling the slots on the face plate away from the plastic holder.

  • Remove the plastic holder from the face plate after the slots are loosened.

Ajouter un commentaire

The plastic holder secures the power button by two slots. Using a spudger, push the holders inward to detach the button from the plastic holder. Using a spudger, push the holders inward to detach the button from the plastic holder.
  • The plastic holder secures the power button by two slots.

  • Using a spudger, push the holders inward to detach the button from the plastic holder.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Tim Wise

Membre depuis le 01/04/2011

170 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 10-38, Forte Spring 2011 Membre de l'équipe Cal Poly, Team 10-38, Forte Spring 2011

CPSU-FORTE-S11S10G38

5 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 6

Total : 3,126