Introduction

The purpose of this guide is to instruct the reader on how to replace the LCD screen of their HP iPAQ H2200 device.

Pièces

Aucune pièce nécessaire.

Press and slide the battery cover tab to remove battery cover.
  • Press and slide the battery cover tab to remove battery cover.

Ajouter un commentaire

Pull on the black tab to lift the battery out of the battery compartment. Pull on the black tab to lift the battery out of the battery compartment.
  • Pull on the black tab to lift the battery out of the battery compartment.

Ajouter un commentaire

Remove the stylus by sliding it out of the slot.
  • Remove the stylus by sliding it out of the slot.

Ajouter un commentaire

Remove the CF card by sliding it out of the slot at the top of the device.
  • Remove the CF card by sliding it out of the slot at the top of the device.

Ajouter un commentaire

Press down and push the black side strips toward the top of the device to remove them.
  • Press down and push the black side strips toward the top of the device to remove them.

Ajouter un commentaire

Using the T5 Torx screwdriver,  remove all six screws on the back and all screws on each side of the device. Using the T5 Torx screwdriver,  remove all six screws on the back and all screws on each side of the device. Using the T5 Torx screwdriver,  remove all six screws on the back and all screws on each side of the device.
  • Using the T5 Torx screwdriver, remove all six screws on the back and all screws on each side of the device.

Ajouter un commentaire

Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side). Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).
  • Remove the back faceplate by pushing and loosening the 4 side slots (2 on each side).

Ajouter un commentaire

Open the LCD connector, where the orange strip attaches to the main board.
  • Open the LCD connector, where the orange strip attaches to the main board.

Ajouter un commentaire

Carefully remove the orange LCD strip from the connector.
  • Carefully remove the orange LCD strip from the connector.

Ajouter un commentaire

Unscrew the 2 screws located at each top corner of the main board.
  • Unscrew the 2 screws located at each top corner of the main board.

Ajouter un commentaire

Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.
  • Remove the main board by pushing outward on the two tabs located on each side near the bottom of the device.

Ajouter un commentaire

Unscrew the two bottom screws on LCD screen that were previously located under the main board.
  • Unscrew the two bottom screws on LCD screen that were previously located under the main board.

Ajouter un commentaire

Press on side tabs to loosen and remove the LCD screen. Press on side tabs to loosen and remove the LCD screen.
  • Press on side tabs to loosen and remove the LCD screen.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Tyler Andrews

Membre depuis le 13/01/2010

191 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 4-12, Forte Winter 2010 Membre de l'équipe Cal Poly, Team 4-12, Forte Winter 2010

CPSU-FORTE-W10S4G12

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 3,658