Introduction

This guild help you how to replace the external stand. The stand may not support the device, this may be because of the spring being over-worn or because of some kind of debris on the surface of the stand. A plastic opening tool and PH0 screwdriver will be needed to accomplish this guide.

Using the plastic opening tool, to open the back panel of the device.
  • Using the plastic opening tool, to open the back panel of the device.

  • Push down on the plastic opening tool, and push the back panel, repeat this for the 4 sides of the device.

Ajouter un commentaire

Kits RAM pour Mac
Accélérez votre Mac. Maximisez sa mémoire.
Kits RAM pour Mac
Augmentez la mémoire de votre Mac.
Using the PH0 screw driver, remove the 7.5 mm screws by turning in  a clockwise direction. There are 6 screws on the front panel.
  • Using the PH0 screw driver, remove the 7.5 mm screws by turning in a clockwise direction. There are 6 screws on the front panel.

  • Remove all of the 7.5 mm screws, by repeating the same step above.

  • After unscrewing the 7.5 mm screws, just lift the plastic and you will see the motherboard.

Ajouter un commentaire

Using the Pentalobe screw driver, unscrew the 5.1 mm screws by applying a clockwise force.
  • Using the Pentalobe screw driver, unscrew the 5.1 mm screws by applying a clockwise force.

  • Remove all of the 5.1 mm screws, and slowly lift the stand. There are 4 screws on the stand.

  • After the stand is removed, replace the stand with a new one.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

yousef aljeemaz

Membre depuis le 18/10/2017

573 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S1-G9, Cagle Fall 2017 Membre de l'équipe USF Tampa, Team S1-G9, Cagle Fall 2017

USFT-CAGLE-F17S1G9

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 14

Total : 98