Introduction

If the case of the shear is cracked and you are concerned about debris getting into the device this guide is what you are looking for.

Locate and remove the six 1.5 cm screws marked on the picture from the shear with a Phillips head #2 screwdriver.
  • Locate and remove the six 1.5 cm screws marked on the picture from the shear with a Phillips head #2 screwdriver.

Ajouter un commentaire

Pull face plate away from the body of the device. Replace similarly, but take caution of loose wires that might have been moved by the removal of the face plate. If the plate with the screw sockets was replaced then the wires will need to be put back into the the depressions on the new plate for the device to be closed up properly. See photo with the blades on the right for proper wire placement.
  • Pull face plate away from the body of the device. Replace similarly, but take caution of loose wires that might have been moved by the removal of the face plate.

  • If the plate with the screw sockets was replaced then the wires will need to be put back into the the depressions on the new plate for the device to be closed up properly. See photo with the blades on the right for proper wire placement.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Adam soto

Membre depuis le 30/01/2015

301 Réputation

3 tutoriels rédigés

Équipe

USF Tampa, Team 17-5, Watkins Winter 2015 Membre de l'équipe USF Tampa, Team 17-5, Watkins Winter 2015

USFT-WATKINS-W15S17G5

3 membres

4 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 100